Search:

Tag: diy

Search: Search took 0.00 seconds.

  1. Best Investment for Special Conditions

    Started by sigilwig444, 02-22-2017 06:43 AM
    cast, diy, investment, plaster
    • Replies: 8
    • Views: 627
    Last Post: 02-22-2017 09:42 PM
    by sigilwig444  Go to last post
  2. Mg-Li-Al alloy: Too risky?

    Started by ober0n, 12-06-2016 12:25 AM
    3 Pages
    1 2 3
    alloy, aluminum, diy, magnesium
    • Replies: 22
    • Views: 1,440
    Last Post: 12-09-2016 02:59 AM
    by ober0n  Go to last post
  3. My 1st waste oil burner design (based on how a nebulizer works)

    Started by joule_ian, 05-22-2016 01:39 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 1,699
    Last Post: 07-04-2016 11:29 PM
    by J. Vibert  Go to last post
  4. Cheap DIY rammer from $30 HF needle scaler

    Started by burntbeard, 11-04-2015 06:40 PM
    diy, rammer, sand rammer
    • Replies: 2
    • Views: 801
    Last Post: 11-04-2015 09:39 PM
    by burntbeard  Go to last post
  5. Lil' Screwy, a DIY (?)100 ton press

    Started by bdneeley, 02-08-2014 08:55 PM
    diy, metal press, tooling
    • Replies: 2
    • Views: 1,568
    Last Post: 02-10-2014 01:43 PM
    by dlciii  Go to last post
  6. Design Advice for Casting Lathe Milling Attachemnt

    Started by johnsnd, 01-17-2014 03:28 PM
    3 Pages
    1 2 3
    • Replies: 24
    • Views: 6,065
    Last Post: 02-22-2014 04:50 AM
    by master53yoda  Go to last post
  7. How to?

    Started by mikefromspace, 08-22-2013 10:22 PM
    diy, iron, melting
    • Replies: 1
    • Views: 900
    Last Post: 08-23-2013 06:03 AM
    by oxide  Go to last post
Results 1 to 7 of 7