Tab Content
No More Results
About rotarysmp

Basic Information

About rotarysmp
Location:
Vienna, Austria
Interests:
Aviation, metal work
Occupation:
Engineer

Statistics


Total Posts
Total Posts
734
Posts Per Day
0.30
General Information
Last Activity
Yesterday 04:46 PM
Join Date
12-01-2010
Referrals
2
View rotarysmp's Blog

Recent Entries

Need some flat plate. Made my own.

by rotarysmp on 12-11-2011 at 09:57 AM
I need some 6mm flat stock to make the motor mounts for my little CNC gantry Mill, so I decided to cast some.



I got heavy shrinkage...



Luckily the pouring spout was long.

Read More

Categories
Uncategorized

Started (yet another) project - Small CNC Gantry Mill

by rotarysmp on 12-11-2011 at 08:01 AM
Hi Guys,

Since you can never have too many unfinished projects floating around, I thought I'd start another one.


The write upo will be...
http://www.cnczone.com/forums/bencht...ting_mill.html

I am sick of having my Mill 1 hours drive away, but the last four houses we offered on we didn't get, so we're still in an apartment.

Read More

Categories
Uncategorized

Machining the pulley

by rotarysmp on 06-19-2011 at 02:39 PM
I have finishing turning the pulley from one side, inclusing the bore and drive key slot. I use the lathes old top slide for shaping slots.

A pivot is bolted to the end of the slide, and an anchor pivot bolted to the cross slide t-slots, behind the shaper slide.


Read More

Categories
Uncategorized

Fourth casting - Pulley

by rotarysmp on 06-17-2011 at 08:17 PM
Thanks Anon for your working on the forum migration.

I needed a pulley for the new mill head I am building. The pattern came out taller than my cope.



To lower the spilt line I molded a pot plant tray.


Read More

Categories
Uncategorized