Tab Content
  • rocco's Avatar
    Today, 12:43 AM
    rocco replied to a thread Propane manifold in Burner engineering
    I don't know but the pressure relief on a standard 20lb tank is set at something like 250psi. In any event the hose in my last picture is for use in...
    16 replies | 154 view(s)
  • rocco's Avatar
    Yesterday, 08:53 PM
    rocco replied to a thread Propane manifold in Burner engineering
    I'm with you on that, I don't particularly like the rigid connection between the two tank, maybe use a hose like THIS instead. Put a brass tee and...
    16 replies | 154 view(s)
  • rocco's Avatar
    Yesterday, 05:25 PM
    rocco replied to a thread Propane manifold in Burner engineering
    This tee and pigtail set up is $25.00 from Zoeller forge.com If you're able to scavenge a POL fitting from an old BBQ regulator, it would be...
    16 replies | 154 view(s)
  • rocco's Avatar
    02-15-2017, 08:35 PM
    I've posted this before, here's a link to tongs very similar to Myfordboy's: http://www.metalworker.eu/gieten/htmlen/tl-tang.htm
    17 replies | 513 view(s)
  • rocco's Avatar
    01-26-2017, 03:00 AM
    If you've using an AC power source, a high voltage ignition system can be made very easily with a few wires and just 4 parts, an automotive ignition...
    10 replies | 408 view(s)
No More Results
About rocco

Basic Information

Statistics


Total Posts
Total Posts
2,853
Posts Per Day
0.80
General Information
Join Date
06-01-2007
Referrals
0

1 Friend

  1. metalmelter2693 metalmelter2693 is offline

    Senior Member

    metalmelter2693
Showing Friends 1 to 1 of 1