• Recent Articles

  • Recent Forum Posts

    HT1

    Aluminum Scrap

    thank you! thank you!! thank you!!!

    Finally more people are hearing this absolute truth. extrusions, normally 6063 and structural

    HT1 Today, 09:26 AM Go to last post
    HT1

    Drainage hole question.

    I have to second Jagboy, two cracks running top to bottom all the way through the cast lining is scary I would guess you got impatient and did not let

    HT1 Today, 09:17 AM Go to last post
    jagboy69

    Drainage hole question.

    IF you have a crucible failure, you might be glad for the hole. It's already there so just leave it. Or do what I do, stuff it with a chunk of kaowool

    jagboy69 Today, 06:03 AM Go to last post
    caster

    Drainage hole question.

    Hi Nickdoobs, when I upgraded my reil burner to an oil blown burner I shut the drain hole. The blower pressurized the furnace and flames/hot exhaust

    caster Today, 05:23 AM Go to last post
    Nickdoobs

    Drainage hole question.

    I'm in the process of converting my charcoal fueled foundry to propane. I saw someone mention drainage holes on another thread. I was planning on filling

    Nickdoobs Today, 04:52 AM Go to last post