• Recent Articles

  • Recent Forum Posts

    r4z0r7o3

    CAD Program for Pattern Making

    I had the same problem, for me it was a combination of not enough "smoosh" to the first layer (too high height calibration), and the bed was

    r4z0r7o3 Today, 06:36 PM Go to last post
    jagboy69

    Pipe for oil burner

    YUP... that gentlemen is a FORGE. This man from the south knows the difference. Good on him!

    Hey you might look at casting a "cone"

    jagboy69 Today, 06:14 PM Go to last post
    jagboy69

    Jumping Castle blower

    Garage sale it. You'll need to block off 95% of it's air intake for it to be any use for you. While it seems like a good idea, it's simply too much

    jagboy69 Today, 06:08 PM Go to last post
    oldironfarmer

    CAD Program for Pattern Making

    I'm learning. My wrench blank is flat, and curling up from the table as it prints. Still printing "ok". Hmmm.

    oldironfarmer Today, 05:21 PM Go to last post
    oldironfarmer

    CAD Program for Pattern Making

    I have enjoyed using Fusion360 on whatever computer I sit down to at home. Really nice that way.

    I received my 3D printer and it had it's

    oldironfarmer Today, 04:44 PM Go to last post